INSULINE LEAK DETECTION

标准/Standward : EN 14419
导线电阻/ Electrical resistance of the wire: 24 Ω /Km
泄漏位置/leak location：反射仪（T DR）
检测距离为 2500 米，<2.5km detection mode and in location.
定位距离为 2500 米。
故障定位Fault Locating Accurate within: 1m
它足够智能，能够识别典型的管道冷凝水和泄漏之间的区
别。Intelligent enough to recognize the difference between typical
pipe condensation and a leak
泄漏定位报警可以通过手机或者邮件发送Alarm Box will
Email & Text when there is a Leak
1根裸露的镀锡铜线“传感器”1 bare tinned copper wire
该系统基于绝缘材料的电传输特性，而绝缘材料的电传输特性会随着其湿度的变化而变化。
根据保温层的含水量，导热钢管与保温层之间的电阻会降低
阻抗测量可以确定水分的位置
系统组成System composition
1根裸露的镀锡铜线1 bare tinned copper wire
Ø mm
该系统由以下部分组成The system consists of:
1根裸铜线“回线”1 copper wire no
The system is based on the properties of electrical transmission in insulation, which varies according to its degree of
humidity.
Depending on the moisture content of the Insulation materical, the electrical resistance between the heat-carrying steel tube
and the monitoring wire decreases.
Reflectometry analysis allows for the localization of humidity.